|
Switches There are six different switch panels to select from: One button, Two button, Three button, Four button, Six button and a Scene switch. All of these are available only in white at present.
Features - 10+ year battery life (CR2032 coin cell) - Battery included and installed (just stick and go) - Stick a switch anywhere (double sided type on backside) - Easily link any button to any receiver or multiple receivers (single-point / multi-point control) - Just as easy to un-link - Press and hold button to dim (if linked to a dimmer unit) - Transmit range: typically 20m to 30m trough walls (range extended by receivers) - Operates in the 915MHz free band - 2 year guarantee on workmanship - Dimensions (HxWxD): 12.5cm x 8cm x 1.4cm
|
|
Email: info@switch70.co.za or Contact: 082 728 4191 (Brought to you by: www.wrnd.co.za) |
|
Receivers Choose from six different receives to suite your needs. Both relay and dimmer receivers come in 250W, 400W and 800W power ratings.
Features: - Operating voltage: 200V to 260V ac, 50Hz - All receivers includes onboard repeaters - Zero voltage turn on (not applicable to dimmers when dimmed) - Zero current turn off - Easily link receiver to one or multiple buttons on any switch (one-way / multi-way switching / dimming) - Just as easy to un-link - Returns to last state after power failure - Overload protection - Over temperature protection - Small form factor - Operates in the 915MHz free band - 2 year guarantee on workmanship - Dimmer also have a soft-on soft-off feature |
|
On the wall A Three button Switch70 switch panel compared to a standard two lever switch. They are both based on the same 4x2 inch standard used throughout the industry.
|
|
Mounting options All standard mounting holes are catered for and each panel comes supplied with two mounting screws. Or just use the bubble sized tape on the back and stick it on the wall. |
|
Small form factor Compare the size of a 400W dimmer (red) and a 250W relay (blue) on the left to a packet of matches. These fit most anywhere and easily slips through down lighter holes. |
|
Quick and easy installation Just replace the block connector used to connect the light fitting to the mains power with the receiver. It is as easy as turning a few screws. |
